Home Maintenance
Tips & Guides

The exact repair method depends on the existing installation and the condition of the sink, countertop and mounting system. In a typical repair, the sink needs to be correctly repositioned, and the bonding surfaces need to be prepared so that a suitable adhesive can form an effective bond. The basin then needs secure support while that bond cures.

A recent HANDLD project involved assembling and installing a compact IKEA kitchenette with four cabinets: two base cabinets and two wall cabinets. The finished installation included a laminate countertop, with the upper cabinets positioned on either side of a basement window.

For a kitchen faucet installation in Toronto, checking the shutoff valves, water connections and available space for a pull-down hose can help prevent leaks, restricted hose movement and installation-day surprises.

A wire closet shelf pulling away from the wall is more than an inconvenience. Once the rear supports loosen, the shelf can sag, shift or eventually come away under the weight of clothing and stored items.

A loose undermount sink is more than a cosmetic problem. If the sink begins separating from a granite, quartz or other stone countertop, the opening can allow water into the cabinet below and place additional stress on the sink connection. Undermount sink repair should address both support and the seal around the sink rather than simply covering a visible gap with more caulk. A recent HANDLD project involved a double-bowl stainless steel undermount sink beneath a stone counte

Small gaps around a shower or tub are worth addressing before repeated water exposure creates a larger maintenance problem. HANDLD provides bathroom caulking, handyman repairs and home maintenance services across Toronto and the GTA. If your shower or tub has cracked, peeling or missing sealant, contact HANDLD to arrange an assessment and repair.

A bifold closet door that comes off its track can become difficult or impossible to close. The good news is that a door that has popped out does not automatically need to be replaced. Depending on the condition of the door and hardware, a bifold closet door off track repair may involve re-seating the door, checking its guides and pivots, and correcting its alignment. On a recent HANDLD service visit, an interior folding closet door had come off its track and would not close p

Once the microwave is mounted and connected, check more than whether it powers on. Test the exhaust fan through its available speeds, operate the task light and listen for unusual vibration. On a ducted installation, duct connections should also be checked for obvious air leakage.

If your towel bar is loose, pulling away from the wall, or has already ripped out of the drywall, simply pushing the screws back into the same holes is unlikely to solve the problem. Once drywall has been crushed around an anchor, that area may no longer provide enough support for the bracket. This is a common bathroom hardware problem, particularly when a towel bar was originally installed with light-duty plastic anchors. The right repair depends on the condition of the dryw

You have the roller blinds, the measurements look right, and installation seems straightforward—until the drill stops just behind the drywall. This is a common challenge when installing blinds in Toronto condos, where the area above a window may have concrete behind a shallow drywall finish. A recent HANDLD project involved installing three IKEA roller blinds across a three-panel Toronto condo bedroom window. The finished installation provided consistent privacy and light con

Turn Rough Basement Walls Into Useful Storage Older Toronto basements can offer plenty of potential storage space, but the walls are not always easy to work with. Exposed or uneven masonry, plumbing, outlets and mechanical equipment can make it difficult to mount shelves or organizers securely. In a basement laundry area, moisture is another consideration. One practical solution is to install pegboard on wood strapping, also called furring strips. Instead of trying to attach